Retaining Wall Material Calculator
Block count and gravel backfill for a retaining wall, with the waste percentage stated.
Blocks are the wall area divided by 0.125 square metres, the face of a 500 x 250 mm block, and backfill is the wall area times 0.3 metres of gravel. Both are multiplied by your waste percentage, in metric units.
A zero or negative length or height is refused by name. The block face and the backfill depth are printed so the count can be checked, and the waste percentage is on the answer line.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
Blocks are the wall area divided by 0.125 square metres, the face of a 500 × 250 mm block, and backfill is the wall area times 0.3 metres of gravel; both are multiplied by your waste percentage. A 6 m wall at 1.2 m high at 10 percent therefore reads 58 blocks and 2.16 m³ of backfill before the allowance, in metric units.
Metric block count and gravel backfill, with the waste allowance on both.
An ordering estimate, not a structural specification.
How to use it
Enter wall length and height in metres and a waste percentage, then press Run. The page prints the wall area, the block count, the backfill volume and both figures after waste.
Waste and units
0.125 m² is the face of one 500 × 250 mm block, which is why the count is area divided by that figure rather than by a brick face. The 0.3 m backfill depth is the page's stated assumption for the drainage layer behind the wall, and the waste percentage covers cutting blocks at the ends and steps.
Where the page stops
A zero or negative length or height is refused by name. The page sizes materials, not stability: it does not check bearing pressure, drainage, surcharge or reinforcement, and a retaining wall above about a metre normally needs an engineer's design.
What to Expect
Best for
- Ordering blocks and drainage gravel for a garden wall.
- Seeing the block face and backfill depth the count rests on.
What this tool keeps
- The block face and the backfill depth print, so both figures can be re-derived.
What may need cleanup
- Nothing: the counts and the volume are the whole output.
Sample input
6 m long, 1.2 m high, 10 percent waste
Sample output
Area: 6 × 1.2 = 7.2 m² Blocks: 7.2 ÷ 0.125 = 57.6 → 58, with 10 percent = 64 Backfill: 7.2 × 0.3 = 2.16 m³, with 10 percent = 2.38 m³
Frequently asked questions
How many blocks and how much backfill?
Enter wall length and height in metres and a waste percentage, then press Run. The page prints the block count and the backfill volume, each with and without waste.
Is anything uploaded?
No. The divisions run in this tab, so nothing is sent, nothing is stored and no account is needed.
Does this check the wall will stand?
No. It sizes materials only: bearing pressure, drainage and surcharge are outside it, and a taller wall normally needs an engineer's design.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.