Rebar Weight & Count Calculator
Bar count, total length and weight for a slab, from spacing, diameter and layer count.
Bars in each direction are the span in millimetres divided by the spacing, plus one, times the layer count. Bar mass is diameter squared over 162 kilograms per metre, in metric units, with your waste percentage added.
A zero or negative span, spacing, diameter or layer count is refused by name, and more than four layers is refused as outside the range the page models. No laps or hooks are added, and the page says so.
Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.
Bars in each direction are the span in millimetres divided by the spacing, plus one, times the layer count, and bar mass is diameter squared over 162 kilograms per metre, with your waste percentage added. A 6 × 4 m slab at 200 mm spacing, 12 mm bar and one layer reads 31 and 21 bars, 250 m, 222.2 kg, and 233.3 kg with 5 percent; units are metric.
Metric bar count, total length and weight, with the waste allowance.
An ordering estimate, not a structural specification.
How to use it
Enter the slab spans in metres, the bar spacing in millimetres, the bar diameter and the layer count, then set a waste percentage and press Run. The page prints the bars per direction, the total length, the weight and the weight with waste.
Waste and units
The plus one is the bar at the far edge, which a plain division would omit. Diameter squared over 162 is the metric mass per metre for steel, so a 12 mm bar is 0.889 kg/m; the page prints that figure rather than assuming it. Waste covers cutting and laps are not added — a lap is a design decision, not an allowance.
Where the page stops
A zero or negative span, spacing, diameter or layer count is refused by name, and more than four layers is refused as outside the range the page models. No laps or hooks are added, and the page says so; cover, anchorage and the bar schedule belong to a structural drawing.
What to Expect
Best for
- Ordering bar stock for a slab from spacing and diameter.
- Seeing the bar count and the tonnage together.
What this tool keeps
- The bars per direction and the mass per metre print, so the tonnage can be rechecked at another diameter.
What may need cleanup
- Nothing: the counts and the weights are the whole output.
Sample input
6 × 4 m slab, 200 mm spacing, 12 mm bar, 1 layer, 5 percent waste
Sample output
Bars: 6000 ÷ 200 + 1 = 31, and 4000 ÷ 200 + 1 = 21 Length: 31 × 4 + 21 × 6 = 250 m Mass: 12² ÷ 162 = 0.889 kg/m → 222.2 kg With 5 percent: 233.3 kg
Frequently asked questions
How many bars and how much do they weigh?
Enter the slab spans, spacing, diameter and layer count, then a waste percentage, and press Run. The page prints the bars per direction, the length and the weight.
Is anything uploaded?
No. The counts and the mass are computed in this tab, so nothing leaves the page and nothing is stored.
Why is more than four layers refused?
Four layers is the range the page models, so a deeper arrangement is refused rather than under-counted.
Is this a structural specification?
Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.