Cubic Yardage Calculator screenshot

Cubic Yardage Calculator

Cubic yards from length, width and depth in feet, with the waste percentage applied first.

Privacy First
0 Runs
Updated 2026-11-06
No upload
Instant
No signup

Cubic feet is length times width times depth in feet, and cubic yards is that figure divided by 27. The waste percentage multiplies the cubic feet before the division, in imperial units, with the metric equivalent printed beside it.

A zero or negative dimension is refused by the field it was typed in. The waste percentage is printed on the answer line, and the page states 27 cubic feet per cubic yard so the division can be checked.

Every figure is an ordering estimate, not a structural specification, and none of it replaces an engineer's take-off. The arithmetic runs in your browser: nothing is uploaded and nothing is stored, so the same input prints the same answer on every reload.

Cubic feet is length × width × depth in feet, and cubic yards is that figure divided by 27, with your waste percentage multiplying the cubic feet before the division. Ten by ten feet at six inches with 10 percent waste therefore reads 55 cubic feet and 2.037 cubic yards; the units are imperial and the metric equivalent prints beside the answer.

Imperial cubic yards, with waste applied before the division by 27.

An ordering estimate, not a structural specification.

How to use it

Enter length, width and depth in feet, set a waste percentage and press Run. The page prints the cubic feet, the same figure with waste, and the cubic yards, with a metric equivalent beside it.

Waste and units

27 cubic feet is one cubic yard, and the page prints that constant so the division can be checked. Waste multiplies the cubic feet before the division rather than the yards after it, which keeps the allowance in the unit the dimensions were entered in and avoids rounding twice.

Where the page stops

A zero or negative dimension is refused by the field it was typed in. The page converts the finished volume to metric but takes no metric input, so a depth in centimetres must be turned into feet before it is typed.

What to Expect

Best for

  • Ordering fill, mulch or concrete by the cubic yard.
  • Checking a supplier's yardage against your own dimensions.

What this tool keeps

  • Cubic feet and cubic yards both print with the waste percentage, so the order can be rechecked.

What may need cleanup

  • Nothing: the three volumes are the whole output.

Sample input

10 ft × 10 ft × 0.5 ft, 10 percent waste

Sample output

Cubic feet: 10 × 10 × 0.5 = 50 With 10 percent waste: 55 ft³ Cubic yards: 55 ÷ 27 = 2.037 yd³

Frequently asked questions

How do I get cubic yards?

Enter length, width and depth in feet and a waste percentage, then press Run. The page multiplies to cubic feet, applies waste, and divides by 27.

Is anything uploaded?

No. The arithmetic is in this tab: nothing is sent anywhere, nothing is stored and no account is needed.

Does it take metric dimensions?

No. Length, width and depth are read in feet, and the metric figure on the answer line is a conversion of the result rather than an input.

Is this a structural specification?

Every figure here is an ordering estimate, not a structural specification: it sizes a purchase, and an engineer's take-off or the manufacturer's data governs what is actually built.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.