Jump Height Estimator screenshot

Jump Height Estimator

Estimate vertical jump height from a measured flight time, using g = 9.81 m/s².

Privacy First
0 Runs
Updated 2026-11-06
No upload
Instant
No signup

Height from airtime

Enter the time your feet were off the ground, in seconds. The page treats the jump as a projectile with g at 9.81 metres per second squared and applies h equals g times t squared divided by 8: half the flight time is the rise, and the height is a half times g times that rise squared. Half a second of airtime is 30.66 cm.

A stopwatch is not a force plate. Reaction time, the moment you start and stop the watch, and a landing that folds your knees all move the figure, and the page cannot see any of them. It also assumes you land at the height you took off from. A flight time of zero is refused, and anything above two seconds is refused as beyond a standing jump.

The square and the division happen in this tab from one number. Nothing is uploaded, no jump is logged, and the same flight time always prints the same height.

Jump height from a measured flight time, with standard gravity: h = g·t² ÷ 8, the eight being two times four because the rise takes half the airtime and h = ½g(t/2)². Half a second in the air reads 30.66 cm, and the page prints the substitution so the constant is visible. This is stopwatch arithmetic: it assumes the take-off and landing heights match and that air resistance is negligible, which is close enough for a vertical jump and wrong for a vault or a drop. It is not a force-plate measurement and cannot see how the jump was produced. Flight time must be above zero.

Jump height from flight time with h = g·t² ÷ 8 using g = 9.81 m/s², a stopwatch estimate rather than a force-plate reading.

How to use it

Film or time the airtime between take-off and landing, enter the seconds and press Run. The output is centimetres with the substitution beside it. Frame-counting a phone video is the most repeatable way to get the input; a hand-timed stopwatch is usually good to about a tenth of a second, which is worth several centimetres.

The arithmetic

Under constant gravity a body that rises and falls back to the same height spends half its airtime rising. Setting the rise distance equal to ½g(t/2)² collapses to g·t²/8, so height grows with the square of flight time — a ten percent longer airtime is a twenty-one percent higher jump. The measurement is therefore most sensitive exactly where a stopwatch is weakest.

Where it stops

Flight time must be above zero, and the estimate assumes take-off and landing at the same height and negligible air resistance. A jump from a box, a landing in a pit or a sport where the feet are not level breaks the assumption. The page reports a kinematic estimate and makes no claim about power, force or training effect.

What to Expect

Best for

  • Turning a filmed airtime into a jump height.
  • Seeing how sensitive the height is to a timing error.

What this tool keeps

  • The flight time is used in the browser and never sent; nothing is retained.

Sample input

0.5 s flight time

Sample output

Jump height 30.66 cm Flight time 0.5 s: 9.81 × 0.5² ÷ 8 = 0.3066 m.

Frequently asked questions

How do I use the jump height estimator?

Measure the airtime between take-off and landing, enter the seconds and press Run. The page prints the height in centimetres with the formula and constant shown.

Is anything uploaded?

No. One multiplication runs in this tab; nothing is posted, nothing is stored, and the page works offline.

What are its limits?

Flight time must be above zero, and the result assumes level take-off and landing with negligible drag. Because height grows with the square of airtime, a tenth of a second of timing error is several centimetres — this is a stopwatch estimate, not a force-plate measurement.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.