Cycling Cadence Tracker screenshot

Cycling Cadence Tracker

Turn a counted number of crank revolutions and a stopwatch reading into pedal cadence in rpm.

Privacy First
0 Runs
Updated 2026-11-06
No upload
Instant
No signup

Revolutions per minute

Count the times one pedal comes over the top, and time the window you counted over. The page multiplies the revolutions by 60 and divides by the seconds, which converts any window into revolutions per minute. Ninety turns in sixty seconds is 90 rpm.

The page does not measure anything itself: it runs no clock and reads no sensor, so the accuracy is your count and your stopwatch. A window of a few seconds magnifies a miscount, which is why thirty seconds or more reads better. A revolution count of zero or a window of zero seconds is refused, because neither produces a cadence.

The conversion happens in this tab from the two numbers you type. Nothing is uploaded and no ride is stored, and the same pair always prints the same cadence.

Cadence is crank revolutions per minute: revolutions × 60 ÷ seconds. Ninety turns in a minute is 90 rpm, and the page prints that figure with the multiplication behind it, so a shorter counting window works the same way — 45 turns in 30 seconds is also 90 rpm. One crank revolution is one count, which makes the arithmetic a unit change rather than a model of pedalling. The page runs no clock: the window is whatever you timed, so a miscounted start costs accuracy in proportion to how short the window was. Revolutions and seconds must both be above zero.

Cadence in rpm from revolutions × 60 ÷ seconds, with the counting window you timed.

How to use it

Count crank revolutions for a measured window, then enter both numbers and press Run. The output is revolutions per minute; the second line shows the multiplication, so a window of 20 or 30 seconds is easy to check. Use one leg's crank or a single sensor magnet — counting both legs' pushes doubles the answer.

The arithmetic

The conversion is a scaling to a one-minute base: revolutions ÷ seconds gives turns per second, and multiplying by 60 gives turns per minute. There is no smoothing, no averaging and no gearing model, so the number is exactly what the two inputs imply. A longer window reduces the effect of a miscounted turn.

Where it stops

Both inputs must be above zero; a zero-second window would divide by zero and is refused. The figure is a sample, not a session average, and it says nothing about speed, gearing or effort. If the count came from a device, its own definition of a revolution may differ from the crank's.

What to Expect

Best for

  • Converting a hand-counted cadence sample into revolutions per minute.
  • Checking a bike computer's cadence against a manual count.

What this tool keeps

  • Your count and window are used in the browser only; nothing is sent or retained.

Sample input

90 revolutions in 60 s

Sample output

Cadence 90 rpm 90 revolutions in 60 s: 90 × 60 ÷ 60.

Frequently asked questions

How do I use the cadence tracker?

Count crank revolutions over a timed window, enter both figures and press Run. The result is revolutions per minute with the multiplication printed underneath.

Is anything uploaded?

No. The division and scaling happen in this tab; no request is made, no data is stored, and the page works offline.

What are its limits?

Revolutions and seconds must both be above zero, and the window should be long enough that one miscounted turn does not dominate. It reports the sample you timed, not a ride average, and it models nothing about gearing or speed.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.