Specific Heat Capacity Calculator screenshot

Specific Heat Capacity Calculator

Calculate specific heat capacity from the heat added, the mass and the temperature change.

Privacy First
0 Runs
Updated 2026-11-06
No upload
Instant
No signup

Specific heat from heat, mass and temperature change

The page divides the heat energy in joules by the mass in grams times the temperature change in degrees Celsius, which gives J/(g*degC). 10450 joules into 100 grams across 25 degrees is 4.18, the figure for water. The second line repeats the substitution.

A temperature change of zero is refused, because the division would be by zero and a sample that did not change temperature says nothing about its heat capacity. The mass must be above zero as well. The heat may be negative, which describes heat released and gives a positive capacity as long as the change is also negative.

The division is the whole calculation. Nothing is stored, nothing is uploaded, and the same three figures give the same capacity on every reload.

The page divides the heat energy in joules by the mass in grams times the temperature change in degrees Celsius and prints the specific heat capacity in J/(g·°C). 10450 J into 100 g across 25 °C gives 4.18, the figure for water, with the substitution repeated beside it.

This is the inverse of the heat-energy calculation: it assumes no phase change, because during melting or boiling the temperature stays constant and the division would carry no information about the material.

How to use it

Enter the heat energy in joules, the mass in grams and the temperature change in degrees Celsius, then press Run. A cooling experiment gives a negative q and a negative ΔT, and the two signs cancel, so the capacity still comes back positive.

  • Enter q in joules.
  • Enter mass in grams and ΔT in °C.
  • Read the capacity in J/(g·°C) and compare it with a table.

The arithmetic, and where it stops

One multiplication in the denominator and one division: q/(m·ΔT). Because both q and ΔT carry the direction of heat flow, their signs cancel and the result is positive for an ordinary measurement — but a positive q with a negative ΔT, or the reverse, means one of the two figures was transcribed with the wrong sign, and the page prints the negative capacity it computes rather than hiding it.

A temperature change of zero is refused, because the division would be by zero and a sample that did not change temperature says nothing about its capacity; the mass must be above zero as well, and both are refused with the field named.

What to Expect

Best for

  • Deriving a material's specific heat from one calorimetry measurement.

What this tool keeps

  • The division runs in this tab; no measurement is uploaded or remembered. The same figures give the same result after a reload.

Sample input

10450, 100, 25

Sample output

c = 4.18 J/(g·°C)

Frequently asked questions

How do I use the Specific Heat Capacity Calculator?

Enter the heat energy in joules, the mass in grams and the temperature change in degrees Celsius, then press Run. A cooling experiment gives a negative q and a negative ΔT, and the two signs cancel, so the capacity still comes back positive.

Does anything leave my browser?

No. The division runs in this tab; no measurement is uploaded or remembered. Reloading the page discards every value you entered.

Which inputs does it refuse?

A temperature change of zero is refused, because the division would be by zero and a sample that did not change temperature says nothing about its capacity; the mass must be above zero as well, and both are refused with the field named.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.