Waist-to-Hip Ratio Risk Calculator
Compute waist-to-hip ratio and read it against the WHO 2008 cut-points of 0.90 and 0.85.
The ratio is waist circumference divided by hip circumference. WHO 2008 sets the cut-point at 0.90 for men and 0.85 for women, and the page prints the one that applies to the sex you select.
A waist or hip of zero is refused because the ratio divides by hip, and a measurement above 300 cm is refused with a note that the fields are in centimetres. This page reports a number and a category, not a diagnosis.
Every figure is computed in your browser from the values you type: nothing is uploaded, nothing is stored, and no account is involved. Reload the page and the same input prints the same answer, because the page keeps no state between visits.
The ratio is waist circumference divided by hip circumference, and WHO 2008 sets the cut-point at 0.90 for men and 0.85 for women; the page prints the one that applies to the sex you select. A 90 cm waist over a 100 cm hip therefore reads 0.90 against the 0.90 cut-point.
Waist over hip, against the WHO 2008 cut-points of 0.90 and 0.85.
How to use it
Select sex, enter waist and hip circumference in centimetres, then press Run. The page prints the division, the ratio and the cut-point for the sex you selected.
The arithmetic
One division, unitless because both sides are centimetres. The cut-point differs by sex because WHO 2008 published two, and the page prints the one it used rather than an average of the two.
Where the page stops
A waist or hip of zero is refused because the ratio divides by hip, and a measurement above 300 cm is refused with a note that the fields are in centimetres. Where the tape sat matters as much as the number, and the page cannot see that; it divides the two figures you give it and compares the result with one published cut-point.
What to Expect
Best for
- Computing waist-to-hip ratio from two tape measurements.
- Seeing the ratio against the WHO 2008 cut-point for your sex.
What this tool keeps
- Both measurements and the cut-point print, so the division can be rechecked.
What may need cleanup
- Nothing: the ratio and the cut-point are the whole output.
Sample input
male, waist 90 cm, hip 100 cm
Sample output
Ratio: 90 ÷ 100 = 0.90 WHO 2008 cut-point (men): 0.90 At the cut-point
Frequently asked questions
How is waist-to-hip ratio calculated?
Select sex, enter waist and hip in centimetres, then press Run. The page divides one by the other and prints the cut-point for that sex.
Is anything uploaded?
No. One division runs in this tab, so nothing is sent, nothing is kept and no account is needed.
Why is a measurement above 300 cm refused?
300 cm is outside the range these circumference cut-points were written for, so the page names the refusal and adds that the fields are in centimetres.
Is this a diagnosis?
No. This page reports a number and a category, not a diagnosis. It applies the published band named on the page and leaves interpretation to a clinician who can see you.
Build custom tools for your store
Join the SDK program to create useful ecommerce utilities for your store.