Guitar String Tuner screenshot

Guitar String Tuner

Check pitch frequencies against standard EADGBE tuning.

Privacy First
0 Runs
Updated 2026-11-06
Sent to this site only
No signup
Nothing stored

Check pitch frequencies against standard EADGBE tuning. Enter your numbers and get an instant result.

Read a measured pitch in hertz and see which string of standard tuning it is nearest, how far off it is in cents, and whether to tighten or loosen.

It is arithmetic on a frequency you supply. It does not listen: there is no microphone, so nothing is detected and nothing is tuned for you.

How to use Guitar String Tuner

Play one string at a time near the microphone and read input_frequency_hz: one clean note measures, a chord does not.

Set target_string_note to the string being tuned, or leave auto to let the tuner pick the nearest string from the frequency.

Tune toward the target_string_note reading rather than away from it: approach from below where the string holds, watching input_frequency_hz settle instead of swinging past.

The maths behind the cents

Standard tuning is E2 82.41, A2 110.00, D3 146.83, G3 196.00, B3 246.94 and E4 329.63 Hz. The distance to a target in cents is 1200 × log₂(measured ÷ target), and a hundred cents is one semitone.

With the target set to auto, the nearest string wins and the deviation is reported against it. Naming a string instead compares against that one only, which is what you want when you already know which peg you are turning.

Where the numbers stop helping

A frequency outside 20 to 1000 Hz is refused as not a plausible acoustic pitch, and a target that is not in the six-string set is refused too. Those bounds exist because a reading below 20 Hz is usually a mis-typed decimal and a reading above 1 kHz is usually a harmonic.

Cents measure pitch, not stability: a string that wobbles by ten cents while you read it is telling you about its nut and its age, and a single number cannot show that. The reading is also only as good as the measurement you type in.

What to Expect

Best for

  • Checking a tuner app's reading against the arithmetic.
  • Seeing how far a string is from pitch without a second app.

What this tool keeps

  • The measured frequency and the chosen target are the input; the deviation in cents and the string it belongs to are derived from them.

Sample input

input 110.4 Hz, target auto

Sample output

A report placing it on A2 with a deviation of a few cents sharp, and the direction to turn the peg.

Frequently asked questions

Does this page use my microphone?

No. There is no audio input at all; you type a frequency that something else measured, and the page does the comparison.

What does a negative cents value mean?

That the measured pitch is below the target, so the string is flat and the peg needs tightening — unless the string is wound the other way.

Can I tune to a dropped tuning?

Only by reading the deviation against the nearest standard string. The six targets are fixed, so a dropped tuning needs the target frequency supplied as a measurement instead.

Developer program

Build custom tools for your store

Join the SDK program to create useful ecommerce utilities for your store.